Topics Topics Edit Profile Profile Help/Instructions Help Member List Member List  
Search Last 1|3|7 Days Search Search Tree View Tree View  

Rod Rigging--Replace or new cold press?

S2 9.1 Class Bulletin Board » Technical Assistance, Fixes & Advice » Rod Rigging--Replace or new cold press? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Jeff Roy
New member
Username: Jeffr

Post Number: 105
Registered: 03-2001

Rating: N/A
Votes: 0 (Vote!)

Posted on Wednesday, September 07, 2005 - 10:24 am:   Edit PostDelete PostView Post/Check IPPrint Post   Move Post (Moderator/Admin Only)Ban Poster IP (Moderator/Admin only)

FWIW I have been getting quotes on this project and the cost of the rods is not a major percentage of the total cost. To me, it doesn't make any sense to skimp there. The Navtang fittings in the mast are ridiculously expensive, over 500$ per set. They add up to almost half the cost of the refurb job. I have been talking to riggers about alternatives to the Navtangs.
Top of pagePrevious messageNext messageBottom of page Link to this message

Ed and Julie Gully
New member
Username: Goldenomen

Post Number: 2
Registered: 05-2001

Rating: N/A
Votes: 0 (Vote!)

Posted on Thursday, April 18, 2002 - 01:50 pm:   Edit PostDelete PostView Post/Check IPPrint Post   Move Post (Moderator/Admin Only)Ban Poster IP (Moderator/Admin only)

William, We on goldenomen here in Key West just had our rig renewed by Florida rigging & Hydralics.
Our contact is Tonya Malone @ 561-863-7444 or 800-718-1649, the tecks name is Chris.
The job was expensive(3260.00), But needed. The tie bars(made of alumium) were corroided to the point I had to break them with pipe wrenches to get the shroud out of the mast.
Navtec made 3 new tie bars and the caps for the rod out of stainless so that should end that problem.6 New turnbuckles,211' of rod and we should be good for another decade!!
Any questions feel free to e-mail me at goldenomen @netscape.net
Hope this is timely,
Ed
Top of pagePrevious messageNext messageBottom of page Link to this message

William Shirley

Rating: N/A
Votes: 0 (Vote!)

Posted on Friday, March 22, 2002 - 02:46 pm:   Edit PostDelete PostView Post/Check IPPrint Post   Move Post (Moderator/Admin Only)Ban Poster IP (Moderator/Admin only)

I just bought "Lightning Rod" in Annapolis and am shipping it down to Florida to race. I do not have any experience with rod rigging. Based on an article from Sailing World, I am considering having the ends of the rod redone by having new heads cold pressed onto the original fittings.

Does anyone have any experience with this? Is this a reasonable precaution? I suspect this might be the original rigging for this 1985 boat.

Any response will be appreciated.
Thanks,
William Shirley

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and moderators may post messages here.
Password:
Options: Enable HTML code in message
Automatically activate URLs in message
Action:

Administration Administration Log Out Log Out   Previous Page Previous Page Next Page Next Page