Brad Stone
New member Username: Bstone
Post Number: 12 Registered: 06-2004
Rating: N/A Votes: 0 | Posted on Tuesday, June 21, 2005 - 10:43 pm: | |
Lance, I'll take a shot at this: I dug up a pic from last year which is not the best but it may give you an idea where mine is located from the outside. It's the thru-hull just forward of the stand, factory installed I believe (lousy white arrow). As well, I took a few measurements inside for you. Sorry about no inside pics here - PC problem at present. I layed a tape measure flush along the curve of the hull, from center-line up to mid-point of the discharge on the port side, and got 21". I then measured off the forward bulkhead, forward to the mid-point again, and got 6 3/4 - 7". My holding tank is under the port settee, and one hose of the three-way goes back there. The direct discharge hose comes through the forward bulkhead, makes a loop and ends at an elbow fitting on the thru-hull. At the dimensions given above, the location is a few inches higher, and slightly forward of that stringer under the v-berth. Hope this helps, and let me know if there's more info that can.
|